DSL-500G ADSL Router User’s Guide
Configure WAN Connection (ADSL Service Connection)
Click on the Quick Configuration hyperlink to access the configuration settings you need to establish the ADSL connection.
Quick Configuration Window
When setting up the Router for the first time, use the Quick Configuration window and follow the steps below to change settings as instructed by your ISP. Some of the settings can be left at their default value depending on the requirements of the connection. Details about the settings listed here can be found in the next chapter.
1.PVC: Leave this set at the default value 0 the first time the Router is set up. For more information on this option see Multiple PVC Operation
2.Operation Mode: This also should be left at the default setting Enabled. This enables the PVC used for the initial connection.
3.Connection Type: Change connection method and packet encapsulation technique as instructed by your ISP. The available connection types are PPPoE LLC, PPPoE
4.VPI: If instructed to change this, type in the VPI value for the initial connection (using PVC 0). Default
=0.
5.VCI: If instructed to change this, type in the VCI value for the initial connection (using PVC 0). Default
=35.
6.Bridge: This may be left t the default setting Disabled. Some users may opt to enable this now by selecting Enabled from the
7.IGMP: Leave this set to Disabled.
8.IP Address: & Subnet Mask: Some users may be required to configure the IP settings for the WAN connection. If you are using IPoA or a Bridged IP connection, you may be instructed by your ISP to enter your global IP settings. If you are told to enter an IP Address and Subnet Mask, enter ithem here.
14