NETGEAR WGR614v9 manual Restoring the Default Password and Configuration Settings

Router Setup Manual

Table 2. Wireless Router Default Configuration Settings (continued)

Feature Default Setting

Interface Specifications

LAN:

WAN:

10BASE-T or 100BASE-Tx, RJ-45

10BASE-T or 100BASE-Tx, RJ-45

Restoring the Default Password and Configuration Settings

You can restore the factory default configuration settings that reset the router’s user name to admin, the password to password, and the IP address to 192.168.1.1.

This procedure will erase all the current configuration settings and restore the factory defaults.

To restore the factory default configuration settings:

1.Use a sharp object such as a pen or a paper clip to press and hold the restore factory settings button, located on the rear panel of the router, for about 20 seconds, until the Test light begins to blink (see “Router Back Panel” on page 4).

2.Release the restore factory settings button, and wait for the router to restart, and for the Test light to turn off.

The factory default settings will be restored so that you can access the router from your Web browser using the factory defaults.

28 Default Configuration

v1.0, July 2008