Router Setup Manual
Manual Setup
There are two steps to setting up your router:
1.Connect the router to the ADSL or cable modem, and connect a computer to the router (see “Connecting Your Router”).
Your computer has to be set to automatically get its TCP/IP network settings from the router through DHCP. This is usually the case. If you are unsure about this, use the wizard on the CD, which automatically takes care of this for you, or refer to the documentation for your computer.
2.Configure the router to use your Internet service (see “Accessing the Wireless Router after Installation” on page 10).
Connecting Your Router
To connect your router:
1.Connect the router, the computer, and the modem.
a.Turn off your computer.
b.Turn off and unplug the cable or ADSL broadband modem.
c.Locate the Ethernet cable (1) that connects your computer to the modem.
1
2
Figure 5
d.Disconnect the cable at the modem end only (2).
Getting to Know Your Wireless Router | 7 |
v1.0, July 2008