NETGEAR wn3000rp user manual Compliance Notification, Regulatory Compliance Information

Page 29

B.Compliance Notification

B

Regulatory Compliance Information

This section includes user requirements for operating this product in accordance with National laws for usage of radio spectrum and operation of radio devices. Failure of the end-user to comply with the applicable requirements may result in unlawful operation and adverse action against the end-user by the applicable National regulatory authority.

Note: This product’s firmware limits operation to only the channels allowed in a particular Region or Country. Therefore, all options described in this user's guide may not be available in your version of the product.

FCC Requirements for Operation in the United States

FCC Information to User

This product does not contain any user serviceable components and is to be used with approved antennas only. Any product changes or modifications will invalidate all applicable regulatory certifications and approvals

FCC Guidelines for Human Exposure

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC Declaration of Conformity

We, NETGEAR, Inc., 350 East Plumeria Drive, San Jose, CA 95134, declare under our sole responsibility that the Universal WiFi Range Extender WN3000RP complies with Part 15 Subpart B of FCC CFR47 Rules. Operation is subject to the following two conditions:

•This device may not cause harmful interference, and

•This device must accept any interference received, including interference that may cause undesired operation.

FCC Radio Frequency Interference Warnings & Instructions

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following methods:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Universal WiFi Range Extender WN3000RP Statement of Conditions Technical SupportTrademarks Table of Contents Getting Started Extender Hardware FeaturesHow the Extender Works When to Use Your ExtenderTo improve the Link Rate LED from red or amber to green Positioning Your ExtenderLog In to the Extender Connect a PC to the Extender with an Ethernet CableUse the Smart Wizard to Set Up the Extender After installation, to use the Smart Wizard again Universal WiFi Range Extender WN3000RP Click Continue Extender Network Settings Connect the Extender to an Existing Network Use WPS to Add a PC to the Extender’s Wireless NetworkPush Button recommended . Either click  To use the Extender WPS button to connectTo log in to the Extender and use WPS to connect To change the wireless settings for the extender’s network Extender Wireless SettingsSet Up WEP To set up WPA or WPA2 in the Extender Extender IP Address SetupSet Up WPA, WPA2, or WPA + WPA2 Status Screen Field Description Show StatisticsAttached Devices Back Up and Manage Extender Settings Erase the Settings Back Up SettingsRestore Settings To check for firmware and upgrade if it is available Set the PasswordUpgrade the Firmware To view or change the advanced wireless settings Advanced Wireless SettingsSmart Wizard FAQs TroubleshootingConnection was not established to the selected network Joining Wireless NetworksSupplemental Information Factory SettingsTechnical Specifications Technical SpecificationsFCC Requirements for Operation in the United States Compliance NotificationRegulatory Compliance Information Europe EU Declaration of Conformity Universal WiFi Range Extender WN3000RP FCC CautionPertinentes de la directive 1999/5/CE Interference Reduction Table Interference Reduction Table
Related manuals
Manual 32 pages 50.17 Kb Manual 36 pages 21.79 Kb
Top Page Image Contents