Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point
How to Configure Wireless Repeating
$3
$3
8ÁjjÄÄË+ | |||
ÄÄW?ÍjaËÝÍË+¤ | |||
ÝÍËËËËWjÍË?ÄÄW?ÍÄ | ÝÍËWjÍË?ÄÄW?ÍÄ | ||
|
$3
5RXWHU
8ÁjjÄÄË+ | ||
ÄÄW?ÍjaËÝÍË+Ï | ||
ÝÍËWjÍË?ÄÄW?ÍÄ | ||
| ||
|
!Ë
.j~jÍˤ
8ÁjjÄÄË+
ÄÄW?ÍjaËÝÍË+Ô
Figure 5-6: Multi-Point bridging
1.Configure the Operating Mode of the WG102 Access Points.
–Configure AP1 on LAN Segment 1 in Repeater mode with the Remote MAC Address of the ‘downstream’ AP (AP2).
–Configure AP2 in Repeater mode with the MAC addresses of the ‘upstream’ AP (AP1) and the MAC address of the ‘downstream’ AP (AP3).
–Configure AP3 in Repeater mode with the Remote MAC Address of the ‘upstream’ AP (AP2).
2.Verify the following parameters for all access points:
• Verify that the LAN network configuration the WG102 Access Points are configured to operate in the same LAN network address range as the LAN devices
• All APs must be on the same LAN. That is, all the APs LAN IP address must be in the same network.
• If using DHCP, all WG102 Access Points should be set to “Obtain an IP address automatically (DHCP Client)” in the IP Address Source portion of the Basic IP Settings menu.
• All WG102 Access Points use the same SSID, Channel, authentication mode, if any, and encryption in use.
3.Verify connectivity across the LANs.
Advanced Configuration |
October 2004