Wiring
Grounding
1.Install and interconnect ground rods appropriate for proper grounding according to local electrical code requirements.
2.Route ground wires from the ground system into the bus bar located on the enclosure.
Connecting Utility Power to the Enclosure
EP3
(EP6 has additional battery tray)
Tamper Switch
Present on all Models
Site for Power Supply
Battery Tray
Electrical Input Output Box
Maintenance Bypass Switch
Auxiliary Power 
Supply Connection
1.Unlock and open the door of the enclosure.
2.Ensure that the utility power switch is OFF.
3.Install a high magnetic circuit breaker box
EP0
Status Monitoring Lamp
Present on all Models
Grounding Wire
Output Connection to Coax
Optional External AC
Generator Interface
To CTSP Utility
Output Terminals
Output Voltage Sensor
4.Using appropriate conduit connectors, run wires from the utility breaker box to the receptacle box inside the enclosure.
5.Connect the wires to the receptacle and install it in the enclosure.
6.Refer to the
5