1USB-LAN EZ-EXTENDER INTERFACES
This chapter provides the setup procedures for both the Blackfin USB-LAN EZ-Extender and EZ-KIT Lite (ADSP-BF533,ADSP-BF537 or ADSP-BF561) and describes each of the interfaces the extender supports.
The information is presented in the following order.
•“USB-LAN EZ-Extender Setup” on page 1-1
•“USB 2.0 Interface” on page 1-3
•“Ethernet Interface” on page 1-4
•“Optional ADSP-BF537 EZ-KIT Lite Interfaces” on page 1-5
USB-LAN EZ-Extender Setup
It is very important to set up all components of the system containing the USB-LAN EZ-Extender before applying power to that system. The fol- lowing procedure is recommended for the correct setup.
Power your system when these steps are completed:
1.Read the applicable design interface section in this chapter—the text provides an overview of the capabilities of the interface.
2.Read “System Architecture” on page 2-2 to understand the physical connections of the extension board. For detailed information, refer to “USB-LAN EZ-Extender Schematic” on page B-1.
Blackfin USB-LAN EZ-Extender | 1-1 |