Aruba Networks FIPS 140-2 manual Label Function Action Status

Page 9

Label	Function	Action	Status

		Flashing	2.4GHz Air monitor

WLAN 5Ghz	5GHz Radio Status	Off	5GHz radio disabled

		On - Amber	5GHz radio enabled in WLAN mode

		On – Green	5GHz radio enabled in 802.11n mode

		Flashing	2.4GHz Air monitor

9

Image 9

Contents Fips 140-2 Non-Proprietary Security Policy Page Aruba Dell Relationship Acronyms and Abbreviations ServicesAruba AP-120 Series Security Levels Physical SecurityPage Aruba Dell Relationship IntroductionAcronyms and Abbreviations GHzLAN Aruba AP-120 Series Product OverviewPhysical Description Aruba Part Number Dell Corresponding Part NumberIndicator LEDs Label Function Action Status PWREnet Label Function Action Status Security Levels Module ObjectivesPhysical Security Applying TELsAP-124 Front view Aruba AP-124 TEL PlacementAP-124 Back view AP-124 Bottom view Aruba AP-125 TEL PlacementAP-125 Front view AP-125 Right view AP-125 Bottom view Inspection/Testing of Physical Security MechanismsModes of Operation Configuring Remote AP Fips ModeEnable Fips mode on the AP. This accomplished by going to Configuring Remote Mesh Portal Fips Mode Configuring Remote Mesh Point Fips Mode Operational Environment Verify that the module is in Fips modeFips 140-2 Logical Interfaces Module Physical Interface Logical InterfacesRoles, Authentication and Services Crypto Officer AuthenticationRoles Wireless Client Authentication User AuthenticationStrength of Authentication Mechanisms Authentication Mechanism StrengthWPA2-PSK Crypto Officer Services ServicesService Description CSPs Accessed see section WPA2 PSKUser Services Service Description CSPsService Wireless Client Services ∙ FTP ∙ Tftp ∙ NTP Unauthenticated ServicesNon-FIPS Approved Algorithms Cryptographic AlgorithmsHmac Critical Security ParametersRNG PSK PTKAES-CCM GTK GMKSelf Tests For an AES Cavium hardware Post failure