PPPoE WAN Mode
A method of connection that requires you to enter a Username and Password (provided by your Internet Service Provider) to gain access to the Internet.
Using the Configuration Interface
Username:
Password:
Verify Password:
Service Name:
Reconnect Mode:
Maximum Idle Time:
PPPoE Connection:
LAN
The username that you use to login to your Internet connection.
Enter the password associated with your username.
Retype the password for verification.
If your ISP requires a service name, enter it here.
Typically PPPoE connections are not always on. The
•Always on: A connection to the Internet is always maintained.
•On demand: A connection to the Internet is made as needed.
•Connect Manually: You have to open up the
Defines how long the machine can be idle before the PPPoE connection is disconnected.
The Disconnect button will immediately terminate any active connection. Note: These buttons become enabled after the router has been rebooted with the PPPoE mode selected.
Basic > WAN > PPPoE
Your internal network settings are configured based on the IP Address and Subnet Mask assigned in this section. The IP address is also used to access this
LAN Settings
IP Address:
Default Subnet Mask:
RIP Announcement: Gateway Metric:
The IP address of the router on the local area network. The local network settings are based on the address assigned here.
The subnet mask of your router on the local area network.
Used with multiple routers to broadcast routing information.
This option is used if you have multiple routers.
21
Basic > LAN