D-Link DI-804V manual Advanced Settings, Dhcp Server Settings

Page 20

Advanced Settings

Advanced settings include DHCP server, virtual server static routing, dynamic routing, filter settings, modem string settings and administration settings.

A username and password will appear. Type “admin” in the user name box, and type the password that you have set the device (the default is no password)

Click OK

The Advanced Settings page will appear.

DHCP Server Settings

The VPN Internet Gateway’s DHCP server is enabled by default. If you would like to disable the DHCP server, unclick on the square circle below.

20

Image 20

Contents Link DI-804V Contents Package Contents Introduction WAN Power 5V DC Connect the DC power adapter to the Power port Firewall Protection IP Address Settings and Computer Settings Static IP settings for the PCUsing the Configuration Utility Basic Setup Click Basic SetupTime Settings Device IP SettingsCable/DSL ISP Settings ISP Additional Settings PPPoE Settings Modem Settings VPN Settings This string is used as key authentication Save & Restart Device Information Device Status Advanced Settings Dhcp Server SettingsVirtual Server Settings Static Routing Dynamic RoutingFilter Settings LAN Filter Settings Filter Settings WAN Filter Settings Modem String Settings Administration SettingsSystem Administration System Parameters Save & Restart Display Routing Table System ToolsIntruder Detection Log System Diagnostics Save Settings Load Settings Load Default Settings Load Settings Load Settings From FileUpgrade Firmware Reset DeviceConfiguring Your PCs to Connect To the DI-804V Router Confirm Your PC’S IP Configuration Ipconfig for Windows 2000/NT/XP Networking Basics Page Page Page Page Page Page Computer Select Properties Computer name Control Panel Connections Page Contacting Technical Support Limited Warranty Registration What You Must Do For Warranty ServiceWhat Is Not Covered