D-Link DI-707P user manual Panel Layout, Front Panel

Page 10

CAT-5 UTP Fast Ethernet Cable

Panel Layout

Front Panel

M1&M2 System status indicators, Orange. M1 is flashed once per second to indicate system is active. When system is busy, M2 is lighted.

Broadband & Ethernet port indicators, Green. The LED flickers when the LAN or WAN

LAN	port is sending or receiving data.
Link/Act.	Link status indicators, Green. The LED flickers when the corresponding
	port is sending or receiving data
10/100	10/100 status indicators, Green. The LED flickers when the
	corresponding port is transmitting or receiving data in 10 or 100Mbps.
Side Panel
RESET	To reset system settings to factory defaults, please follow the steps:

1.Power off the device

2.Press the reset button and hold

3.Power on the device

4.Keep the button pressed about 5 seconds

5.Release the button

6.Watch the M1 and M2 LEDs, they will flash 8 times and then the M1 will flash once per second

POWER Power port. Connect one end of your included power adapter to the

power port and the other end into your power outlet

-10-

Image 10

Contents DI-707P Table of Contents Page Functions and Features IntroductionUser-Definable Application Sensing Tunne l Access Control supportedVirtual Server supported DMZ Host supportedIntroduction to Broadband Router Technology Introduction to FirewallsIntroduction to Local Area Networking Introduction to Virtual Private NetworkingPoint -to-Point Tunneling Protocol Pptp Contents of Package DI-707P Ethernet Broadband RouterPanel Layout Front PanelInstallation Requirements PrinterNetwork Settings Is the TCP/IP of your computers properly configured? Configuring the Ethernet Broadband Router Start-up and LogDevice Information Useful Tools Setup PPP over Ethernet Dynamic IP AddressDial-up Network ∙ Input the Pptp Account and Password Dhcp Server Virtual Server Special Applications Access Control Miscellaneous Items MAC Address Control MAC Address ControlConnection control Configuring on Unix based Platforms IP AddressAppendix a Resetting the System Password or IP Address Install TCP/IP Protocol into Your PC Appendix B TCP/IP Configuration for Windows 95/98Go to Start Settings , then click Control Panel Select Microsoft in the Network Protocols list Set TCP/IP Protocol for Working with the DI-707P Page Don’t input any value in the Gateway tab Choose Disable DNS in the DNS Configuration tab Page Page Page Technical Specifications ∙ 10% ~ 90% Contacting Technical Support Mail support@dlink.com PhoneLink Locations Worldwide Barcelona Limited Warranty Product Type Warranty PeriodWhat You Must Do For Warranty Service What Is Not Covered CE Mark Warning Registration