D-Link airpremier n dual band poe access point manual Switch or Router Internet DAP-2565

Option 1:

Deploying Your Access Point with Dynamic IP Addressing

If your network automatically assigns IP addresses ( DHCP service ), connect the Access Point directly to the network by plugging an Ethernet cable into the LAN port on its rear panel. Insert the cable’s other end into your existing switch or router with Internet connectivity.

No additional configuration is required. Within a few minutes the Access Point will self configure and become ready to use. You have the option of later reconfiguring your Access Point to a static IP address using the CloudCommand™ interface .

The DAP-2565 is PoE ( Power over Ethernet ) compliant. You can power it either by using a PoE switch or the included power adapter. Once powered, the green power LED will turn ON to indicate proper operation.

Switch or Router

Internet

DAP-2565

4