D-Link BEFCMU10 manual Installing the USB Driver for Windows

Page 10

Instant BroadbandTM Series

Installing the USB Driver for Windows 2000

1.Insert the Setup Utility CD into the CD-ROM drive. Windows will notify you that it has detected new hardware.

2.When the Found New Hardware Wizard screen appears to confirm that the USB Modem has been identified by your PC, make sure the Setup Utility CD is in the CD-ROM drive and click Next.

EtherFast® Cable Modem with USB and Ethernet Connection

3.Select Search for a suitable driver for my device and click the Next but- ton.

4.Windows will now search for the driver software. Select CD-ROM drives and click the Next button.

14

15

Page 9 Page 11
Image 10
Page 9 Page 11
Contents EtherFast Cable Modem UG-BEFCM10-10802NC DG Table of Contents IntroductionSystem Requirements Package ContentsOverview Rear Panel USB Cable IconConnecting Using the Ethernet Port Connecting the Cable Modem with USB to Your PCFront Panel Connecting Using the USB Port Installing the USB Driver for WindowsInstant BroadbandTM Series Installing the USB Driver for Windows Millennium Installing the USB Driver for Windows On Connecting Using the USB Port to finish the set up Troubleshooting Common Problems and SolutionsInstalling the TCP/IP Protocol AppendixFor Windows 95, 98, or Millennium users Renewing Your PC’s IP AddressSpecificationspecifications EnvironmentalWarranty Information Contact InformationCopyright 2001 Linksys, All Rights Reserved
Top Page Image Contents