®
A Division of Cisco Systems, Inc.
2 |
| Configure the Router |
|
|
|
|
|
|
There are two ways to configure the Router. Choose one of the following:
•Run the Setup
•Use this Quick Installation guide - If you wish, you can use the Router’s
1 |
| Connect the Router |
|
|
|
D If you have a second phone line, repeat step C to connect a telephone or fax machine to the Router’s PHONE 2 port.
E Connect your cable or DSL modem’s Ethernet cable to the Router’s Internet port. (If your modem only provides a USB output, then you will need to upgrade your modem.)
F Power on the cable or DSL modem.
E
In Step 2, you will need the setup instructions provided by your Internet Service Provider (ISP). If you do not have this information, then contact your ISP before proceeding.
The instructions from your ISP tell you how to set up your PC for Internet access. Because you are now using the Router to share Internet access among several computers, you will use the setup information to configure the Router instead of your PC.
NOTE: Make sure your PC’s Ethernet adapter is set to obtain an IP address automatically. For more information, refer to Windows Help.
Package Contents
•Broadband Router with 2 Phone Ports
•Power Adapter
•Setup Wizard
•Installation and Troubleshooting Guide
•Network Cable
•Telephone Jack Adapter
•Quick Installation
Broadband Router
with 2 Phone Ports
|
|
|
| Quick Installation | |||
VoIPVoIP |
|
|
| ||||
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| Model No. |
|
| |||
|
|
|
| ||||
|
|
|
|
|
|
|
|
A Make sure that all of your hardware is powered off, including the Router, PCs, and cable or DSL modem.
B Connect one end of an Ethernet network cable to one of the numbered ports on the back of the Router. Connect the other end to an Ethernet port on a network device, e.g., a PC, print server, or switch.
Repeat this step to connect more PCs or other network devices to the Router.
C If necessary, disconnect the telephone cable from the telephone wall jack and connect that end to the telephone jack adapter. Then connect the adapter to the Router’s PHONE 1 port.
B
C
NOTE: Make sure your telephone is set to its tone setting (not pulse).
G Connect the included power adapter to the Router’s Power port, and then plug the power adapter into an electrical outlet.
The Power LED on the front panel will light up as soon as the power adapter is connected properly.
H Power on the PC you wish to use to configure the Router.
G
A Open your PC’s web browser. Enter http://192.168.15.1 (the Router’s default local IP address) in the web browser’s Address field. Then press the Enter key.
B A screen will appear and ask you for a User Name and Password. Enter admin (the default) in the User Name and Password fields. (Later you should set a new password using the Administration tab’s Management screen. This will help secure access to the
Then click the OK button.
A
B