Wireless-G Broadband Router with 2 Phone Ports
Placement Options
There are three ways to place the Router. The first way is to place it horizontally on a surface, so it sits on its four rubber feet. Another option is to install the stand onto the bottom of the Router, so the Router is in an upright position. Make sure to place the Router’s bottom edge of the Cisco logo in between the stand’s prongs until tight. The third way is to mount it on a wall.This option uses the Router’s four
To use the
1.Make sure you have four screws that are size
2.Determine where you want to mount the Router.
3.Drill four holes into the wall. Make sure adjacent holes are 60 mm (2.36 inches) apart.
4.Insert a screw into each hole, and leave 5 mm (0.2 inches) of its head exposed.
5.Maneuver the Router so the
6.Place the
Proceed to “Chapter 5: Configuring the
on how to configure the Router.
Chapter 4: Connecting the
60mm
(2.36 inches)
Figure 4-10: Measurement between Wall-
Mount Slots
12
Placement Options