Linksys WAP11 v2.2 manual Status Tab

Page 14

Instant Wireless™ Series

Figure 6-7

Click the Apply button to apply your changes or Cancel to cancel your changes. If you require online help, click the Help button.

The Status Tab

The “Status” tab, shown in Figure 6-8, will display current information on the Access Point, its settings and performance.

•Firmware Version. This displays the current version of the Access Point’s firmware. Firmware should only be upgraded if you experience problems with the Access Point and can be upgraded from the Help tab.

•IP Address. This IP address is the unique address to your network.

•Subnet Mask. The Access Point’s Subnet Mask (also known as a IP Mask), which is the same as your Ethernet network.

•Gateway. This setting indicated the Network’s Gateway mask, only appli- cable when DHCP is enabled.

•Send and Recv. The Send and Recv fields under the LAN’s status display the amount of packets sent and received. Some packet loss is normal in wireless networking.

Wireless Network Access Point

Figure 6-8

•SSID. The unique name shared among all points in your wireless network is displayed here.

•Encryption Function. The encryption method you chose in the Setup Wizard or changed from the Setup Tab of this Web-based Utility is dis- played here.

•Channel. The wireless channel shared by all wireless devices connected to this Access Point is displayed here.

•Send and Recv. The Send and Recv fields under the Wireless’s status dis- play the amount of packets sent and received. Some packet loss is normal in wireless networking.

20

21

Page 13 Page 15
Image 14
Page 13 Page 15
Contents
Wireless Network Access Point Copyright & Trademarks Table of Contents Introduction Instant WirelessTM Network Access PointFeatures System Requirements Planning Your Wireless NetworkPackage Contents Network TopologyPower Wireless Network Access Point’s PortsDipole Antenna Connectors Reset ButtonConnecting the Wireless Network Access Point Instant WirelessTM Series Instant WirelessTM Series Instant WirelessTM Series Configuring the Wireless Network Access Point Setup TabSetting WEP Encryption Instant Wireless Series Password TabStatus Tab Filter Tab Log TabHelp Tab Wireless Tab Instant WirelessTM Series Appendix a Troubleshooting Frequently Asked QuestionsWhat is DSSS? What is FHSS? And what are their differences? What is ISM band?What is Spread Spectrum? What is WEP?Select Specify an IP Address Setting Up TCP/IP in WindowsTCP/IP Setup for Windows 95, 98, and Millennium Select Use the following IP Address TCP/IP Setup for Windows NTTCP/IP Setup for Windows Appendix C Glossary Instant WirelessTM Series Instant WirelessTM Series Instant Wireless Series Appendix D Specifications EnvironmentalAppendix F Contact Information Appendix E Warranty InformationTechnical Support RMA Issues Fax Sales InformationCopyright 2002 Linksys, All Rights Reserved
Top Page Image Contents