Linksys E1000-RM manual Wall-Mounting Placement, Suggested Mounting Hardware

Linksys E1000 Chapter 1: Product Overview

Wall-Mounting Placement

The Router has two wall-mount slots on its bottom panel.. The distance between the slots is 152 mm..

Two screws are needed to mount the Router..

Suggested Mounting Hardware

2..5-3..0 mm

4-5 mm

1-1..5 mm

NOTE: Cisco is not responsible for damages incurred by unsecured wall-mounting hardware..

Follow these instructions:

1.Determine where you want to mount the Router.. Make sure that the wall you use is smooth, flat, dry, and sturdy.. Also make sure the location is within reach of an electrical outlet..

2.Drill two holes into the wall.. Make sure the holes are 152 mm apart..

3.Insert a screw into each hole and leave 3 mm of its head exposed..

4.Position the Router so the wall-mount slots line up with the two screws..

5.Place the wall-mount slots over the screws and slide the Router down until the screws fit snugly into the wall-mount slots..

152 mm

Print this page at 100% size..

Cut along the dotted line, and place on the wall to drill precise spacing..

Wall-Mounting Template

Wireless-N Router 2