Instant BroadbandTM Series
The Cable/DSL Voice Router’s Front Panel LEDs
The LAN Indicators
Net2Phone |
|
In Use | Green. The Net2Phone LED illuminates when there is an |
| open phone connection. |
Power | Green. The Power LED illuminates when the Router is pow- |
| ered on. |
Link/Act | Green. The Link/Act LED serves two purposes. If the LED |
| is continuously illuminated, the Router is successfully con- |
| nected to a device through the corresponding port (1, 2, 3 |
| or 4). If the LED is flickering, the Router is actively send- |
| ing or receiving data over that port. |
Full/Col | Green. The Full/Col LED also serves two purposes. If this |
| LED is continuously illuminated, the connection made |
| through the corresponding port is successfully running in |
| Full Duplex mode. If the LED is flickering, the connection |
| is experiencing collisions. Infrequent collisions are normal. |
| If this LED is flickering too often, there may be a problem |
| with your connection. Check the Troubleshooting section if |
| you think there is a problem. |
100Orange. The 100 LED illuminates when a successful 100Mbps connection is made through the corresponding port.
EtherFast® Cable/DSL & Voice Router powered by Net2Phone
The WAN Indicators
Link | Green. The Link LED illuminates when a successful con- |
| nection is made between the Router and your Broadband |
| device or network. |
Act | Green. The Act LED flickers when the Router is sending or |
| receiving data over the broadband port. |
Diag | Red. The Diag LED illuminates when the Router goes |
| through its |
| off upon successful completion of the diagnosis. If this |
| LED stays on for an abnormally long period of time, refer |
| to the Troubleshooting section. |
6 | 7 |