Actiontec electronic GT704WG user manual 108

Page 113

Actiontec Wireless Cable/DSL Router User Manual

2.This device must accept any interference received, including interference that may cause unwanted operation.

☞Note: To comply with FCC RF exposure compliance require- ments, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.

For questions regarding your product or the FCC declaration, contact:

Actiontec Electronics, Inc.

760 North Mary Ave.

Sunnyvale, CA 94086

United States

Tel: (408) 752-7700

Fax: (408) 541-9005

108

Image 113

Contents Wireless DSL Gateway Table of Contents Configuring Parental Controls Configuring Security SettingsConfiguring the Gateway’s Utilities TroubleshootingGlossary Service Acronyms 103 SpecificationsLimited Warranty 109 107This page left intentionally blank Introduction1 Package ContentsMinimum System Requirements FeaturesGetting to Know the Gateway Wireless Light Power LightDSL Light Internet LightEthernet Ports Reset SwitchDSL Port USB PortPower port is used to connect the Power cord to the Gateway Power PortPower Switch Power switch is used to power the Gateway on and offAccessing Quick Setup Screens Performing a Quick SetupTo access the Quick Setup screens Then press Enter on the keyboardPage Performing a Quick Setup Changing the Password Performing a Quick Setup This page left intentionally blank Broadband Connection Status Viewing Gateway’s StatusPage Viewing the Gateway’s Status Network Status Accessing Wireless Setup Configuring4 Wireless SettingsPage Configuring Wireless Settings Wireless Advanced Settings Basic Wireless SetupWEP WEP+802.1x WPA Page Wireless Status This page left intentionally blank Accessing Advanced Setup Screens Configuring5 Advanced SettingsPage Configuring Advanced Settings Dhcp Settings DSL SettingsEnding IP Address Beginning IP AddressSubnet Mask Enter the IP address of the Dhcp server’s subnet mask hereDomain Name LAN IP AddressDNS Dynamic or Static DNS ServerWAN IP Address Page Configuring Advanced Settings QoS Settings Upstream Rule List DestinationQoS Settings Downstream Remote Management/Telnet QoS StatusTelnet Telnet Timeout SettingRemote Management Static Routing Dynamic RoutingUSB Port Detection UPnP Universal Plug and PlayRemote Syslog Capture Time ZoneThis page left intentionally blank Accessing Wired Security Screens Configuring6 Security SettingsSee Changing the Password on Admin User Name and PasswordFirewall Page Low Applications DMZ Hosting Port Mapping NAT Network Address TranslationAccessing Parental Control Screens Configuring7 Parental ControlsServices Blocking Website Blocking Schedule Rules Configuring Parental Controls Page Accessing the Utilities Screens Configuring Gateway’s UtilitiesPage Upgrade Firmware Restore Default SettingsWeb Activity Log Multiple PVCSystem Log OAM Ping Test Ping Test RebootPage Troubleshooting TroubleshootingLAN Connection Failure Cannot Connect to the InternetCMD Time out error occurs when entering a URL or IP Address Frequently Asked QuestionsWhich protocols does the Gateway support? Which connection speeds does the Gateway support?Yes, the Gateway has a built-in DSL Modem Wireless Is the Gateway flash-upgradeable? How do I do it?Which wireless cards will work with the Gateway? Will my Xbox work with the Gateway?How do I find out what IP address my computer is using? What is the valid IP range I can use for my home network?Yes, if the application is designed to run over a network No. Follow these steps to refresh your IP addressConnections How many computers can be connected through the Gateway?What is NAT and how does it protect my network? What is the default username for the Gateway?Security Does the Gateway function as a firewall?This page left intentionally blank Locating Computer Information ReferenceLocating Windows Operating System Files Appendix a Reference Click Search Windows 98 SE Switching to Static IP On the ComputerPage Do not include the periods they are automatically entered Enter the following numbers in the Subnet mask text box Windows MeAppendix B Switching to Static IP on the Computer Do not include the periods they are automatically entered Windows Page Appendix B Switching to Static IP on the Computer Do not include the periods they are automatically entered Windows XP Page Appendix B Switching to Static IP on the Computer Enter the following address in the IP Address text box Computer Security Comparing DSL Service with a Dial-Up ModemInternet Browsers Gateway SecurityComputer Security Electronic Security Page General Specifications DLED Indicators Wireless Operating RangePower, DSL, Internet, Ethernet, USB, Wireless EnvironmentalGlossary Access Point100 Ssid 102 EndPoint Mapper. Uses UDP 135 and TCP Service AcronymsService Acronym Definitions Uses TCP IMAP, IMAPv3DSuses UDP 445 and TCP 445 -GCuses TCP Smtp 106 Class B Equipment Regulatory Compliance NoticesModifications 108 109 Limited Warranty110 Limited Warranty 112