Troubleshooting, Specifications | Allied Telesis AT-MC101XL specs

Installation Guide

Troubleshooting

To troubleshoot your media converter, perform the following:

1.Set the unit in the Link Test mode.

2.End stations used with the media converter must operate in the same duplex mode (either both full-duplex or both half-duplex).

3.Verify that the twisted pair cable is Category 5.

4.Verify that proper fiber cable is being used: multimode for the AT-MC101XL and AT-MC102XL, and single mode for the AT-MC103XL and AT-MC103LH. Refer to Table 3 on page 10 for cable specifications

5.Verify that the near end node transmitter (TX) is connected to the far end node receiver (RX) and vice versa on the fiber segment.

Technical Specifications

Table 2 lists the media converter technical specifications.

Table 2 Media Converter Technical Specifications

Specifications

Dimensions	4.125 in W x 3.75 in D x 1.0 in H
	(10.5 cm W x 9.5 cm D x 2.5 cm H)

Max. Operating temperature	0° C to 40° C (32° F to 104° F)

Max. Storage temperature	-20 oC to 80o C (-4° F to 176° F)
Operating altitude	up to 10,000 ft (3,048 m)

Humidity	5% to 80% (noncondensing)

EMI/RFI	meets FCC Class A, EN55022 Class A

Safety	EN60950, UL 1950, CSA 950
	EN60825

Immunity	EN50082-1 Immunity Standard

Power
Input supply voltage	12 V DC +/-5%
Max. current	500 mA
Power consumption	6W