User Manual | English |
Instructions
Setup
1.Plug the USB receiver dongle into the USB port of your PC and turn on the Voice Recorder.
2.Double click the Wireless Recorder icon on your desktop to run the software.
3.Check the Connection Status LED to ensure a connection has been made. (if a connection is not made please refer back to the Installation guide on page 3)
4.Check the volume of the sound recording device, before recording, by going to Start >> Control Panel >> Sounds and Audio Devices. Then choose the Audio tab as shown below and select Volume. You can now adjust the recording volume.
Recording
1.Press Record to begin recording
2.If you want to create a chapter/section, press Sec/Stop to create your first section. Then press it again to create a second section (if required) and repeat as required.
3.When you are ready to stop recording press File Up/Save to end and save the recording.
Playback
1.Press Play/Pause to begin playback of the last file recorded.
2.Press Sec/Stop to stop the playback.
File selection
1.Press File Up/Save and File Down to scroll through the recordings you have made. As soon as you stop scrolling, the selected recording will start to playback so that you can check whether it is the correct recording.
2.Once you have the correct recording, use Section Up/Fast Forward and Section Down/Rewind to move to the section of the recording you want to listen to.
3.To Fast Forward press Section Up/Fast Forward and hold for at least 0.5 seconds. To Fast Rewind press Section Down/Rewind and hold for at least 0.5 seconds.
- 5 -