Connecting your VCR

Overview of the equipment, continued

Accessories

Carefully remove the VCR from the carton. Check that the VCR has not been damaged. The following accessories are included.

1 Wireless Remote Control		2 Coaxial cable for
NOTE : Required 2 ‘AAA’		connecting the VCR to your
batteries.		TV’s VHF terminal.

To get a replacement remote, please call1-800-DAEWOO8(1-800-323-9668) to get a replacement remote and talk to parts department.

You must connect your VCR to an external antenna or cable system. Next you will connect the VCR to the television. Follow the directions below to make these connections. You will normally only make one of the connections shown below, not all of them.

Connecting an antenna to the VCR

•If your antenna ends in a single coaxial lead, press or screw the cable onto the ANT. IN terminal on the back of your VCR.

VCR

ANT.IN

•If your antenna ends in a pair of 300 ohm twin leads, use a 300-ohm/75-ohm adapter

(Not Supplied). Place the leads underneath the screws on the adapter, tighten the screws, then press the adapter onto the VCR ANT. IN terminal.

VCR

ANT.IN

Antennas with two sets of leads

You may have two sets of leads from your antenna system.

•If your antenna system has both a coaxial lead and twin 300-ohm leads, purchase a combiner (available at electronics stores). Press or screw the coaxial lead onto the combiner; place the twin leads underneath the screws on the combiner and tighten the screws. Press the cable from the combiner onto

the ANT. IN terminal on the back of your VCR.

Daewoo Video Cassette Recorder User’s Guide