Daewoo DV-T8DN manual Using video cassettes

Page 13

Setting up your VCR, continued

Selecting output channel (CH3 or CH4)

Using video cassettes

you must set output channel for your VCR

choosing either CH3 or CH4. To set the out channel :

1Press MENU to display the menu.

2Press 5 to select output channel.

3Press 5 to toggle the setting between CH3 and CH4.

When the desired output channel is displayed, Press MENU twice to exit

*The default output channel is setup CH3

Audio-visual material may include works of copyright which must not be recorded without authorization of the copyright owner.

If you insert a video cassette without a safety tab into the VCR:

•After setting the timer recording program, “ ” will blink on the display panel in the power off mode and the VCR will automatically eject the cassette.

In the power on mode, the VCR will playback automatically

If you insert a video cassette with a safety tab intact into the VCR:

After setting the timer recording program,the VCR will be stand-by mode in power off mode.

!

Do not attempt to pull out the video cassette once the VCR begins to load the video cassette.

Do not insert fingers or any foreign object beyond the door flaps of the cassette compartment; this could lead to injury or equipment damage.

Do not attempt to insert a video cassette if the VCR in unplugged.

Before you play or record on a video cassette tape, be certain to read this information on the proper care and use of video cassettes.

Only use video cassettes that bear the VHS mark: .

There are four types of video cassettes: T-60, T-90, T-120, and T-160. The amount you can record on a tape is dependent upon the tape speed at which you record. The table below lists the recording time(hours:minutes) for each tape type according to recording speed.

Tape

SP Mode

EP Mode

Type

(Standard Play)

(Extended Play)

T-60

1:00

3:00

T-90

1:30

4:30

T-120

2:00

6:00

T-160

2:40

8:00

Protecting video cassettes from accidental erasure

Cassettes have a safety tab to prevent erasure. Break off the safety tab with a screw driver. If you wish to record on a cassette without a safety tab, cover the hole with cellophane tape.

Inserting video cassettes

Firmly insert the cassette into the cassette compartment with the label up. An inverted cassette cannot be inserted.

Removing video cassettes

Press STOP/EJECT on the VCR front panel and the VCR will eject the tape. Pull the cassette out gently.

19

Daewoo Video Cassette Recorder User’s Guide

Daewoo Video Cassette Recorder User’s Guide

20

Image 13
Contents Video Cassette Recorder Important Safeguards Safety informationContents Overview of the equipment Overview of the equipmentAntenna terminal Selections when using the menu system100 Select channels greater thanSlow Up / Down 14 CH/TRACKING Up / Down17 FF 23 ATRYou may have two sets of leads from your antenna system Connecting your VCRANT. in terminal on the back of your VCR Connecting your VCR Terminal Setting up your VCR Setting up your VCRTurn on the television Press Menu to display the menu Press 3 to select Channel Set Press 2 to select Add/Remove Channels Using video cassettes Watching recorded programs Watching recorded programsTo stop a video cassette, press Stop Recording programs Press 1 to select Timer RecordingsRecording programs Press Menu to display the menuReviewing timer programs When the program contents to be erased is Using advanced featuresDisplayed, press Clear to cancel it To record a programUsing advanced features Spring Forward Fall Backward Duplicating video cassettes tape with another VCR Glossary TroubleshootingTroubleshooting Daewoo Electronics Corporation of America Warranty