GSMVLP5 GSM and
ILP5 Ethernet
Communications Modules
Installation and Setup Guide
Installing Communication Modules
RF Exposure
!WARNING: The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be
Installing the GSMVLP5 in the LYNX Touch Series Control
Ensure that SIM card and the connector board are securely installed in the GSMVLP5 before installing the module in the LYNX Touch.
1. Install the provided FCC/IC label (P/N
| LYNX TOUCH SERIES |
| |
FCC ID: | |
IC: | IC MODEL: LYNXTOUCHG1 |
CONTAINS TRANSMITTER MODULE | |
FCC ID: QIPMC55I | IC: |
| |
|
|
|
|
LYNX TOUCH SERIES
FCC ID: |
|
IC: | IC MODEL: LYNXTOUCH1 |
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES AND RSS 210 OF INDUSTRY
CANADA. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS
DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
COMPLIES WITH FCC RULES, PART 68 FCC REGISTRATION NO.: AC3AL05BL5000
RINGER EQUIVALENCE: 0.1B
Figure 1. FCC/IC Label Location
2.Release the LYNX Touch front case from the back case by depressing the two locking tabs at the top of the unit with the blade of a medium size screwdriver (Refer to Figure 2).
3.Install the GSMVLP5 into the LYNX Touch control front case. Ensure that the connector board is properly seated into the receptacle on the control (Refer to Figure 2).
4.Secure the GSMVLP5 with the three provided screws (Refer to Figure 2).
5.Enable the GSMVLP5 device, configure alarm reporting and module supervision and register the device. Refer to the “Program the Radio” and “Diagnostics” sections in the LYNX Touch Series Installation and Setup Guide (P/N
For Documentation and Online Support: http://www.security.honeywell.com/hsc/resources/MyWebTech