Toshiba QOSMIO G20 manual Ejecting the optical disk Disassembling the ODD assembly

4 Replacement Procedures 4.13 Optical disk drive

4.13.2 Ejecting the optical disk

CAUTION: The following procedure is emergency cope only when the optical disk inside ODD can not be ejected because of some failure.

Disassembling the ODD assembly

The following describes the procedure for ejecting the optical disk from the optical disk drive (See Figure 4-22).

1. Remove the following screws securing the ODD cover.

‰ M1.8x2.0C S-THIN FLAT BIND screw x4

2.Remove the ODD cover from the ODD base assembly by opening it toward the arrow pointed.

3.Hold the optical disk and lift it out.

M1.8x2.0C S-THIN FLAT BIND

ODD cover Hook

Slot

Optical disk

M1.8x2.0C S-THIN FLAT BIND

ODD base assembly

Figure 4-22 Ejecting the optical disk

QOSMIO G20 Maintenance Manual (960-511) [CONFIDENTIAL] 4-37