Antec P193 V3 user manual Connecting the Front I/O Ports, Usb

CONNECTING THE FRONT I/O PORTS

3.1 USB 2.0

Connect the front I/O panel USB cable to the USB header pin on your motherboard. Check the motherboard manual to ensure that it matches the table below:

12

9 10

Pin	Signal Names	Pin
1	USB Power 1	2
3	Negative Signal 1	4
5	Positive Signal 1	6
7	Ground 1	8
9	Key (No Connection)	10

Signal Names

USB Power 2

Negative Signal 2

Positive Signal 2

Ground 2

Empty Pin

3.2 USB 3.0

There is a pre-routed cable for the front-panel USB 3.0 port. Plug the back end of this cable into an on- board USB 3.0 port on your motherboard to enable the front USB 3.0 port.

3.3 AC'97 / HD AUDIO PORTS

There is an Intel® standard 10-pin AC’97 connector and an Intel® 10-pin HDA (High Definition Audio) connector linked to the front panel of the case.

106 4 2

9 7 5 3 1

Pin

1

2

3

4

5

6

7

8

9

10

Signal Names		Pin
(HDA)
MIC2 L	1
AGND	2
MIC2 R	3
AVCC	4
FRO-R	5
MIC2_JD
	6
F_IO_SEN	7
Key (no pin)	8
FRO-L	9
LINE2_JD	10

Signal Names (AC’97)

MIC In

GND

MIC Power

NC

Line Out (R) Line Out (R)

NC

Key (no pin) Line Out (L) Line Out (L)

You can connect either the AC’97 or the HDA connector, depending on the model of the motherboard. Locate the internal audio connectors from your motherboard or sound card and connect the corresponding audio cable. Consult your motherboard or sound card manual for the pin-out positions. Even if your system supports both audio standards, you may only use one connector.

9