Side Panel TriCool™ Fan – This Big Boy 200™ fan is placed in the side panel of the case, ensuring proper cooling of the hottest graphics cards and motherboard equipment.
Big Boy 200™ Specifications:
Size: | 200 x 30 mm |
Rated Voltage: | DC 12V |
Operating Voltage: | 10.2V ~ 13.8V |
Speed (RPM)
High
800
Medium
600
Low 400
Input
Current
0.3A
(Max.)
0.17A
0.08A
Air Flow
3.8m³ / min (134 CFM)
3.1m³ / min (108 CFM)
2.3m³ / min (83 CFM)
Static
Pressure
(0.02
(0.01
Acoustic
Noise
29dBA
27dBA
24dBA
Input
Power
3.6W
2.0W
1.0W
Note: The minimum voltage to start a 120mm TriCool™ fan is 5V. We recommend that you set the fan speed switch to High if you choose to connect the fan(s) to a fan control device or to the
4.2OPTIONAL FANS
There are three optional 120 mm fan mounts – two front fans and a middle fan (at the rear of the upper HDD cage). These three fans should be installed so that the air is blowing into the case from the front.
Front Fans – The front fans are designed to enhance the HDD cooling.
Middle Fan – The middle fan is designed to cool the VGA solution in your computer. In this case, the HDD cage acts as a duct, drawing cool air from the front of the case. You can choose to mount only the middle fan or you can mount both the front and the middle fan to enhance cooling. If you decide to mount any HDD into the upper cage you will not be able to use the middle fan.
1.Find the two fan wire brackets from the hardware kit box.
2.Install the wire brackets into the HDD cage.
3.Clip the fan into position.
12