12.Open the two cable clamps at the bottom of the chassis and disconnect the front panel board connector from the logic board.(Figure 10)
Figure 10
Installing the Replacement Cable
1.Route the cable through the opening in the optical drive shelf so the end of the cable that has the pull tab is up near the front panel board.
2.Connect the cable to the front panel board.
3.Attach the cable along the channel in the side chassis and route the cable through the cable clamps on the bottom of the chassis.
4.Connect the cable to the logic board.
5.Route the speaker cable back in its cable guides and to the connector on the logic board.
Power Mac G4 (Mirrored Drive Doors/FW 800) Front Panel Board Cable - 7