Acer X1300, AS001 manual English

Page 21

11

Notice for New Zealand

1The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it imply that any product is compatible with all of Telecom's network services.

2This equipment is not capable, under all operating conditions, of correct operation at the higher speeds for which it is designed. Telecom will accept no responsibility should difficulties arise in such circumstances.

3Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the equipment (PC) associated with this device. The associated equipment shall be set to operate within the following limits for compliance with Telecom's Specifications:

a There shall be no more than 10 call attempts to the same number within any 30 minute period for any single manual call initiation, and

b The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt and the beginning of the next call attempt.

4Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the equipment (PC) associated with this device. In order to operate within the limits for compliance with Telecom's specifications, the associated equipment shall be set to ensure that automatic calls to different numbers are spaced such that there is not less than 5 seconds between the end of one call attempt and the beginning of another.

5This equipment shall not be set up to make automatic calls to Telecom's 111 Emergency Service.

6This device is equipped with pulse dialing while the Telecom standard is DTMF tone dialing. There is no guarantee that Telecom lines will always continue to support pulse dialing.

7Use of pulse dialing, when this equipment is connected to the same line as other equipment, may give rise to bell tinkle or noise and may also cause a false answer condition. Should such problems occur, the user should NOT contact the telecom Fault Service.

8This equipment may not provide for the effective hand-over of a call to another device connected to the same line.

9Under power failure conditions this appliance may not operate. Please ensure that a separate telephone, not dependent on local power, is available for emergency use.

English

Image 21
Contents User Guide AcerSystemCopyright 2009 All Rights Reserved AcerSystem User Guide Information for your safety and comfort Safety instructionsTurning the product off before cleaning Safe listening Using electrical powerAdditional safety information Disposal instructionsProduct servicing Energy Star Mercury advisoryFinding your comfort zone Tips and information for comfortable useDeveloping good work habits Taking care of your visionContents Page Your computer consists of the following System tourNecessary to know before setup Setting up your computerSelecting a location Opening the packageConnecting peripherals Starting your computerShutting down your computer System upgrade Setting up new componentsOpening the computer Frequently asked questions English Cleaning and servicing To clean your computer and keyboard Taking care of your computerImportant tips To clean an optical mouse To clean your pointing deviceTo clean your monitor When to contact a service technicianFCC notice Regulations and safety noticesRemarque à lintention des utilisateurs canadiens Operation conditionsDeclaration of Conformity for EU countries List of applicable countriesEnglish Laser compliance statement Digital audio output statementRadio device regulatory notice General Federal Communications Commission Declaration of Conformity Acer Europe SA Article 3.1b EMC V09A3