Integrated Peripherals
Parameter | Description | Option |
|
|
|
IDE Function Setup | Press Enter to access the IDE Function Setup submenu. |
|
|
|
|
MCP Storage Config | Press Enter to access the MCP Storage Config submenu. |
|
Init Display First | Select whether to boot the system using the AGP graphic card or a PCI | PCIEx |
| card installed on the PCI Express slot or PCI slot. | PCI Slot |
|
| Onboard |
|
|
|
HD Audio | Enables or disables the onboard audio controller. | Auto |
|
| Disabled |
|
|
|
HDMI Audio | Allows you to control the audio function of the onboard HDMI. | Disabled |
|
| Auto |
|
|
|
MAC LAN | Enables or disables the | Auto |
|
| Disabled |
|
|
|
IDE HDD Block Mode | When enabled, the BIOS will automatically detect if your hard disk | Enabled |
| supports block transfers and set the proper block transfer settings for it. | Disabled |
| Depending on the IDE controller, up to 64 KB of data can be transferred |
|
| per interrupt when block transfers are enabled. |
|
| When disabled, only 512 bytes of data can be transferred per interrupt. |
|
|
|
|
Onboard Serial Port 1 | Select the I/O address and IRQ for the first serial port. | 3F8/IRQ4 |
|
| 2F8/IRQ3 |
|
| 3E8/IRQ4 |
|
| 2E8/IRQ3 |
|
| Auto |
|
| Disabled |
|
|
|
Onboard Parallel Port | Select the I/O address and IRQ for the onboard parallel port. | 378/IRQ7 |
|
| 278/IRQ5 |
|
| 3BC/IRQ7 |
|
| Disabled |
|
|
|
Parallel Port Mode | Select an operating mode for the onboard parallel port. | SPP |
|
| EPP |
|
| ECP |
|
| ECP+EPP |
|
|
|
ECPM Mode Use DMA | Select DMA channel for the LPT port in ECP mode. This parameter can | 3 |
| be configured if the parallel port mode is set to ECP or ECP +EPP | 1 |
| mode. |
|
USB Device Setting | Press Enter to access the USB Device Setting submenu. |
|
|
|
|
20 | Chapter 2 |