Acer E700 manual Introduction of Connectors and Headers, System Board Jumper Setting, Front Panel

Introduction of Connectors and Headers

System Board Jumper Setting

Features	Default Setting	Remark (color and other)
Intruder pin (1*2) & default	No active	Short will have the warning
setting		message The case has been
		opened, press F1 to continue.
BIOS_SEL1 (1*2) & default	Enable SPI
setting

Clear CMOS (1*3) & default setting

2-3: normal (default)

OBR (1*2) & default setting No active

System Board Header Setting

Front Panel

# Pin Definition Description

FP1

1	Orange1	Green2	2
3			4
	Orange3	Green4
5			6
	Blue5	Red6
7			8
	Blue7	Red8
9
	Black9
11			12
	Orange11 Green12
13			14
	Orange13 Green14
	Header_2X7_K10

1	5V_SYS	Hard disk LED pull-up (330 ohm) to
		5V_SYS
2	GPIO_GRN_HDR_R	Pull-up (330 ohm) to 5V_SB_SYS and
		connect To to SIO GPIO
3	HDD_LED_R	Hard disk active LED
4	GPIO_YLW_HDR_R	Pull-up (330 ohm) to 5V_SB_SYS and
		connect to SIO GPIO
5	GND	Reset button
6	PSIN	Power button
7	ICH_SYS_RSTJ	ICH_SYS_RSTJ
8	GND	Ground
9	5V_SYS	5V_SYS
10	Key	Key
11	NC	Reserved
12	GND	Ground
13	NC	Reserved

14 LAN_ACTJ LAN active LED

Chapter 5 56