Stand Installation

With the Metrologic stand (Part #45475), the scanner can be positioned in one of two directions. The two orientation choices are vertical or horizontal. (Refer to Figure 1)

To install this stand, use the four 6-
32 x ½ inch machine screws and two
#10 panhead wood screws.	Figure 1

1.Drill two holes into the work surface that are the same size and distance as the holes on the stand base. (Refer to Figure 2)

2.Use the two #10 panhead wood screws to attach the stand to the work surface.

3.To fasten the scanner:

!For a horizontal mount, align the four holes on the back of the scanner with the four clearance holes located on the stand marked with an X in Figure 3.

!For a vertical mount, align the four holes on the back of the scanner with the four clearance holes located on the stand marked with a Y in Figure 3.

Base of Stand

Figure 2

Figure 3

4.Fasten the scanner to the stand by inserting the four 6-32 x ½ inch screws into the four holes in the scanner’s case.