Metrologic Instruments SP5500 manual Lcd & Led

Page 14

Installation

Settings

SETTING

Clock

Backlight ON Period

CPU Speed

Powering Off the Terminal

Power On Options

Key Click

System Password

DESCRIPTION

Set date and time for the system.

Set the duration for the keyboard/LCD backlight

Set CPU running speed. There are five speeds available: Full speed, half speed, quarter speed, eighth speed and sixteenth speed.

Set time threshold for automatically power off when no operation is taking place during that specified period. If this value is set to zero, this function will be disabled.

There are two possible selections: Program Resume, which starts from the program being used during the last session before the last power-off; and Program Restart, which starts with a new program.

Select a tone for the beeper or disable the beeper when the user presses a key button.

Set a password to protect the user from entering the system menu.

DEFAULT

N/A

the light goes off after 20

seconds

Full speed

10 minutes

Program Resume

Enable

no password is set

Tests

The OptimusS has numerous tests available to the user for both operation and diagnostics. Depending on the application program that is in the active memory will determine which tests can be performed and are available to the user. The following table provides a description of the available tests.

SETTING

Reader

Buzzer

LCD & LED

Keyboard

Memory

 

DESCRIPTION

 

 

 

 

 

 

DEFAULTS

 

 

 

 

 

To test the reading performance of the scanner. The following symbologies are enabled for the Reader test. All other symbologies will need to be enabled via programming.

Default Bar codes: Code 39, Industrial 25, Interleave 25,Codabar, Code 93, Code 128, UPCE, UPCE with ADDON 2, UPCE with ADDON 5, EAN8, EAN8 with ADDON 2 EAN8 with ADDON 5, EAN13, EAN13 with ADDON 2, EAN13 with ADDON 5

To test the buzzer with different Frequency/Duration. Press ENTER key to start and then press any key to stop the test.

To test LCD display and LED indicator. Press ENTER key to start and then press any key to stop the test.

To test the rubber keys. Press a key and the result will be shown on the LCD display. Note that the FN key should be used in conjunction with numeral keys.

To test the data memory (SRAM). Note after the test, the contents of the memory space will be wiped out.

Warning: This test erases any data stored in the terminal.

13

Image 14
Contents SP5500 OptimusS Series User’s Guide Page Table of Contents Page Product Overview Scanner and AccessoriesIntroduction General Features and Characteristics Item no DescriptionMultifunctional Keypad 3BSLithium-Ion Battery LCD ScreenInstallation Getting StartedCommunication and Data Collection Setup Basic OperationInstallation Data Upload System Menu Options Information Settings Tests Memory Power Load ProgramSystem Module InformationLCD & LED Load Application Size InfoInitialize Programming the terminal ApplicationRun Program Utilities Programming the communication cradleTroubleshooting SymptomMB Sram SpecificationsCPU EMC Scan AreasContact Information and Office Locations Corporate HeadquartersSouth America and Central America Brazil MercSafety Notices