Clevo M860TU manual Removing the System Memory RAM, RAM Module Removal

Removing the System Memory (RAM)

The computer has two memory sockets for 200 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting DDRIII (DDR3) Up to 1066 MHz. The main memory can be expanded up to 4GB. The SO-DIMM modules supported are 1024MB and 2048MB DDRIII Modules. The total memory size is automatically detected by the POST routine once you turn on your computer.

Memory Upgrade Process

1.Turn off the computer, turn it over and remove the battery (page 2 - 5) and the component bay cover (page 2 - 6).

2.The RAM module(s) will be visible at point 1 on the mainboard.

3.Gently pull the two release latches (2 & 3 ) on the sides of the memory socket in the direction indicated by the arrows (Figure 5b).

a.	b.		c.
	2	3	4
	1

Disassembly

Figure 5

RAM Module

Removal

a. Locate the memory socket.

b. Pull the release latch(es).

c. Remove the mod- ule(s).



Contact Warning

Be careful not to touch the metal pins on the module’s connecting edge. Even the cleanest hands have oils which can attract particles, and degrade the module’s performance.

2.Disassembly

4.The RAM module(s) 4 will pop-up (Figure 5c), and you can then remove it.

5.Pull the latches to release the second module if necessary.

6.Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.

7.The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot as it will go. DO NOT FORCE IT; it should fit without much pressure.

8.Press the module in and down towards the mainboard until the slot levers click into place to secure the module.

9.Replace the component bay cover and the screws (see page 2 - 6).

10.Restart the computer to allow the BIOS to register the new memory configuration as it starts up.



4. RAM Module

Removing the System Memory (RAM) 2 - 9