Disassembly
Figure 8
Processor
Installation
a. Insert the CPU.
b. Turn the release latch to- |
wards the lock symbol. |
c. Remove the sticker from |
the heat sink and insert |
the heat sink. |
Processor Installation Procedure
1.Insert the CPU 
A , pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE IT!), and turn the release latch 
B towards the lock symbol 
(Figure 8b).
2.Remove the sticker 
C (Figure 8c) from the heat sink.
3.Insert the heat sink 
D as indicated in Figure 8c.
4.Tighten the CPU heat sink screws in the order 
1 to 
4 and 
5 to 
8 (the order as indicated on the label and Fig- ure 8d).
5.Replace the component bay cover and tighten the screws (see page 2 - 6).
d. Tighten the screws. |
a.c.
C
A
C
2.Disassembly
D
b. | d. |
|
|
|
|
| B |
|
|
|
|
| 7 | 5 |
|
| |
3 | 1 |
|
|
| |
A. CPU |
| 6 | 8 | Note: |
|
D. Heat Sink |
|
| |||
• 8 Screws | 2 | 4 |
| Tighten the | screws in |
| the order as | indicated | |||
|
|
|
|
on the label.