Clevo M575A manual Removing the System Memory RAM, RAM Module Removal

Removing the System Memory (RAM)

The computer has two memory sockets for 200 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting DDRII (DDR2) 533 MHz. The main memory can be expanded up to 2GB. The SO-DIMM modules supported are 256MB, 512MB and 1024MB DDRII Modules. The total memory size is automatically detected by the POST routine once you turn on your computer.

Memory Upgrade Process

1.Turn off the computer, and turn it over remove the battery (page 2 - 5).

2.Remove screws 1 - 11 and remove the component bay cover 12 .

3.Gently pull the two release latches 13 - 14 on the sides of the memory socket in the direction indicated by the arrows (Figure b).

a.	2 3 4		c.
1			b.
11	12	5

108

9 7 6 15 15

b.

1314

4.The RAM module 15 will pop-up (Figure 3c), and you can then remove it.

5.Pull the latches to release the second module if necessary.

6.Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.

7.The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot as it will go. DO NOT FORCE IT; it should fit without much pressure.

8.Press the module down towards the mainboard until the slot levers click into place to secure the module.

9.Replace the bay cover and the screws (Figure 3a).

10.Restart the computer to allow the BIOS to register the new memory configuration as it starts up.

Disassembly

Figure 3

RAM Module

Removal

a. Remove the screws and the cover.

b. Pull the release latch(es).

c. Remove the mod- ule(s).



Contact Warning

Be careful not to touch the metal pins on the module’s connecting edge. Even the cleanest hands have oils which can attract particles, and degrade the module’s performance.



12. Component	Bay
Cover
15. RAM Module

• 11 Screws

2.Disassembly

Removing the System Memory (RAM) 2 - 7