7.Plug the antenna cable connector into the port, which is located just below the plastic tab, on the end of the AirPort Card. Make sure the connector is straight before inserting it into the card.
8.Push the AirPort Card down into its space until the antenna cable connector is secured by the small antenna clip.
Important: Route the antenna cable between the edge of the computer and the AirPort Card. Verify that the cable is away from the edge of the computer so that it will not be pinched during reassembly and that it does not sag down into the PC card slot area (below the AirPort Card). Take up any extra cable by tucking it in, where shown.
Tuck in here
if needed
Computer | Plastic Tab |
Case Edge |
|
Antenna
Cable
Antenna
Clip
Antenna Cable
Connector
9.Fold the plastic tab on the AirPort Card over the top of the card.
Note: The plastic tab must be folded over the card during the installation of the bottom case, otherwise you will not be able to securely attach the bottom case to the computer.
8 - PowerBook G4 AirPort Card