Apple G4 installation instructions Closing the Computer

Page 9

Closing the Computer

1.To attach the bottom case, align the notches on the right and left sides of the case (some of these can be viewed through the battery opening). Then press down and toward you slightly to secure the case.

Verify that the case lies flat and fits properly around the battery latch and that the alignment tab that protrudes on the underside of the bottom case, shown in the illustration below, has seated properly.

The case edges should line up smoothly.

Note: Applying pressure to the bottom case at the back of the battery compartment opening, near the latch, and on the front and back outside edges of the case can help with alignment.

2.Check that the eight screw holes on the case align with the holes on the computer. Verify that the display rests on your lap as shown on page 2.

3.Replace the eight screws (in the order shown in the illustration below). Do not overtighten or damage could result.

Note: The screws must go in straight and easily; if not, readjust the bottom case for proper alignment.

Important: To avoid damaging the case, be careful that the screwdriver tip does not slip out of the screw head during tightening.

8

5

Tab

6

7

 

2

4

1

 

3

PowerBook G4 AirPort Card - 9

Image 9
Contents Electrostatic Discharge ESD Tools RequiredOpening the Computer Page Page Installing the AirPort Card AirPort Card Connector Antenna Cable Clip Antenna Cable Connector Holder Tuck in here If needed Closing the Computer DVD slot Gap
Related manuals
Manual 4 pages 51.63 Kb Manual 104 pages 10.41 Kb Manual 88 pages 18.35 Kb Manual 88 pages 62.92 Kb Manual 139 pages 43.17 Kb Manual 293 pages 18.7 Kb