Alienware M14X service manual Before You Begin, Recommended Tools, Turning Off Your Computer

Page 4

Back to Contents Page

Before You Begin

Alienware® M14x Service Manual

Recommended Tools

Turning Off Your Computer

Before Working Inside Your Computer

Contacting Alienware

This manual provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that the following conditions exist:

You have performed the steps in Turning Off Your Computer and Before Working Inside Your Computer.

You have read the safety information that shipped with your computer.

A component can be replaced or—if purchased separately—installed by performing the removal procedure in reverse order.

Recommended Tools

The procedures in this document may require the following tools:

Small flat-blade screwdriver

Phillips screwdriver

Plastic scribe

BIOS executable update program at support.dell.com

Turning Off Your Computer

CAUTION: To avoid losing data, save and close all open files and exit all open programs before you turn off your computer.

1.Save and close all open files and exit all open programs.

2.Click Start , and then click Shut Down.

The computer turns off after the operating system shutdown process finishes.

3.Ensure that the computer and any attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut down your operating system, press and hold the power button for at least 8 to 10 seconds until the computer turns off.

Before Working Inside Your Computer

Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your own personal safety.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).

CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal mounting bracket. Hold a component such as a processor by its edges, not by its pins.

CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty.

CAUTION: When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented and aligned.

CAUTION: To avoid damaging the computer, perform the following steps before you begin working inside the computer.

1. Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.

Image 4
Contents Page Removing the Battery Pack Battery PackReplacing the Battery Pack Page Before You Begin Recommended ToolsTurning Off Your Computer Before Working Inside Your ComputerContacting Alienware System Setup Configuring the System SetupAdvanced Menu Wireless Menu Removing the Base Cover Base CoverReplacing the Base Cover Removing the Bluetooth Card Internal Card With Bluetooth Wireless TechnologyReplacing the Bluetooth Card Back to Contents Removing the Coin-Cell Battery Coin-Cell BatteryReplacing the Coin-Cell Battery Back to Contents Display Assembly Removing the Display AssemblyReplacing the Display Assembly Removing the Thermal Fan Thermal FanReplacing the Thermal Fan Back to Contents Flashing the Bios Click Enter a Service TagHard Drive Removing the Hard DriveReplacing the Hard Drive Removing the Thermal Cooling Assembly Thermal Cooling AssemblyReplacing the Heat Sink Back to Contents Center-Control Cover Removing the Center-Control CoverReplacing the Center-Control Cover Removing the Mini-Card Board Mini-Card BoardReplacing the Mini-Card Board Back to Contents Keyboard Removing the KeyboardReplacing the Keyboard Status-Light Board Removing the Status-Light BoardReplacing the Status-Light Board Memory Modules Removing the Memory ModulesReplacing the Memory Modules Click Start → Control Panel→ System and Security→ System Wireless Mini-Cards Removing the Mini-CardsReplacing the Mini-Cards Wlan 2 antenna cablesOptical Drive Removing the Optical DriveReplacing the Optical Drive Back to Contents Palm-Rest Assembly Removing the Palm-Rest AssemblyReplacing the Palm-Rest Assembly Processor Module Removing the Processor ModuleReplacing the Processor Module Removing the Power-Button Board Power-Button BoardReplacing the Power-Button Board Back to Contents Removing the Speakers SpeakersReplacing the Speakers Back to Contents Removing the Subwoofer SubwooferReplacing the Subwoofer Back to Contents System Board Removing the System BoardReplacing the System Board Entering the Service Tag in the Bios Back to Contents
Related manuals
Manual 122 pages 1.88 Kb