68 | 3 Troubleshooting my computer |
|
|
Error Messages | Corrective Action |
|
|
One or more I2O Block Storage Devices were excluded from the Setup Boot Menu
There was not enough room in the IPL table to display all installed I2O
Operating system not | Operating system cannot be located on either |
found | drive A: or drive C:. Enter Setup and see if fixed |
| disk and drive A: are properly identified. |
|
|
*Parity Check 1 nnnn | Parity error found in the system bus. BIOS |
| attempts to locate the address and display it on |
| the screen. If it cannot locate the address, it |
| displays nnnn. Parity is a method for checking |
| errors in binary data. A parity error indicates that |
| some data has been corrupted. |
|
|
*Parity Check 2 nnnn | Parity error found in the I/O bus. BIOS attempts to |
| locate the address and display it on the screen. If |
| it cannot locate the address, it displays nnnn. |
Press <F1> to resume, <F2> to Setup, <F3> for previous
Displayed after any recoverable error message. Press <F1> to start the boot process or <F2> to enter Setup and change the settings. Press <F3> to display the previous screen (usually an initialization error of an Option ROM, i.e., an
Run the I2O | One or more unclaimed block storage devices |
Configuration Utility | have the Configuration Request bit set in the LCT. |
| Run an I2O Configuration Utility (e.g. the SAC |
| utility). |
|
|
If you still encounter problems after going through the corrective measures, please contact your dealer or an authorized service center for assistance. Some problems may be solved using the BIOS Setup Utility.