Acer M5400(G) manual Viewing Bios checkpoints, Bootblock Initialization Code Checkpoints

Checkpoints

A checkpoint is either a byte or word value output to I/O port 80h.The BIOS outputs checkpoints throughout bootblock and Power-On Self Test (POST) to indicate the task the system is currently executing. Checkpoint sare very useful in aiding software developers or technicians in debugging problems that occur during the pre- boot process.

Viewing BIOS checkpoints

Viewing all checkpoints generated by the BIOS requires acheckpoint card, also referred to as a POST card or POST diagnostic card. These are ISA or PCI add-in cards that show the value of I/O port 80h on a LED display. Checkpoints may appear on the bottom right corner of the screen during POST. This display method islimited, since it only displays checkpoints thatoccur after the video card has been activated.

Bootblock Initialization Code Checkpoints

The Bootblock initialization code sets up the chipset,memory, and other components before system memory is available. The following table describes the type of checkpoints that may occur during the bootblock initialization portion of the BIOS.

NOTE: Please note that checkpoints may differ between different platforms based on system configuration.Checkpoints may change due to vendor requirements,system chipset or option ROMs

from add-in PCI devices.

Checkpoint	Description
Before D0	If boot block debugger is enabled, CPU cache-as-RAM functionality is enabled at this point.
	Stack will be enabled from this point.
D0	Early Boot Strap Processor (BSP) initialization like microcode update, frequency and other
	CPU critical initialization. Early chipset initialization is done.
D1	Early super I/O initialization is done including RTC and keyboard controller. Serial port is
	enabled at this point if needed for debugging. NMI is disabled. Perform keyboard controller
	BAT test. Save power-on CPUID value in scratch CMOS. Go to flat mode with 4GB limit and
	GA20 enabled.
D2	Verify the boot block checksum. System will hang here if checksum is bad.
D3	Disable CACHE before memory detection. Execute full memory sizing module. If memory
	sizing module not executed, start memory refresh and do memory sizing in Boot block code.
	Do additional chipset initialization. Re-enable CACHE. Verify that flat mode is enabled.
D4	Test base 512KB memory. Adjust policies and cache first 8MB. Set stack.
D5	Bootblock code is copied from ROM to lower system memory and control is given to it. BIOS
	now executes out of RAM. Copies compressed boot block code to memory in right
	segments. Copies BIOS from ROM to RAM for faster access. Performs main BIOS
	checksum and updates recovery status accordingly.
D6	Both key sequence and OEM specific method is checked to determine if BIOSrecovery is
	forced. Main BIOS checksum is tested. If BIOS recovery is necessary,control flows to
	checkpoint E0. See Bootblock Recovery Code Checkpoints sectionfor more information.
D7	Restore CPUID value back into register. The Bootblock-Runtime interface module is moved
	to system memory and control is given to it. Determine whether to execute serial flash.
D8	The Runtime module is uncompressed into memory. CPUID information is stored in memory.
D9	Store the Uncompressed pointer for future use in PMM. Copying Main BIOS into memory.
	Leaves all RAM below 1MB Read-Write including E000 and F000 shadow areas but closing
	SMRAM.

50 Chapter 4