Source Technologies ST9510 manual PJL Info Micr Command

1.If you are using a printer driver that is set to 600 DPI, the printer data stream should include a Unit of Measure PCL command set to 600. The command is <ESC>&u600D

2.If the application controls the printer data stream, add the Unit of Measure command early in the data stream. The command also affects X & Y positioning commands. Add <ESC>&u600D

3.After calling the E-13B MICR font, issue a HMI (Horizontal Motion Index) command set to 8 characters per inch. The command must be included with every E-13B MICR font call using either the Selection String or ID call. The command string is:

<ESC>(10O<ESC>(s0p8h8v0s7b360T<ESC>&k15H font data	The	Selection String
<ESC>(30802X<ESC>&k15H font data	The	ID Call

See Font Mapping Appendix pages for specific character set data for each font.

PJL INFO MICR COMMAND

The ST Secure MICR Printer supports an optional custom bi-directional PJL Inquiry Command. The command provides printer information and cartridge information for network management. The command format is; @PJL INFO MICR

The command should be sent with UEL (Universal Exit Language) commands. Example:

<ESC>%-12345X	UEL
@PJL INFO MICR	INFO MICR Command
<ESC>%-12345X	UEL

The following data is returned

@PJL INFO MICR	= READY
PRINTER STATE
	= BUSY
SERIAL NUMBER	= NOT READY
	= XXXXXXXX
PAGECOUNT	= 123456
CARTRIDGE TYPE	= NORMAL
	= MICR

CARTRIDGE STATUS = UNKNOWN

=OK

=LOW

=EMPTY

CARTRIDGE SERIAL# = XXXXXXXX

TONER LEVEL	= 0-9
CARTRIDGE COUNT	= UNKNOWN
	= XXXX
LOW THRESHOLD	= XXXX
EMPTY THRESHOLD	= XXXX
ST Secure MICR Printer User’s Guide	22	2006, Source Technologies
March 2006		All Rights Reserved