6.Locate the cutout template.
7.Use a pencil and the cutout template to trace the speaker outline in the desired locations on the wall.
8.Use a drywall saw to cut along the penciled line.
9.Slip the mounting bracket through the opening and pull it toward you so that its front edge slides into the hole and stops in place.
10.Attach the frame to the bracket by screwing the frame to the bracket using the supplied screws. NOTE: Do not over tighten the screws, this will distort the frame and the grille will not fit.
11.The screws should pull the frame and bracket together (sandwiching the drywall) so that the frame is flush with the wall surface.
12.Strip 1/4” of insulation from the end of each wire.
Figure 2
13.Tightly twist the end of each wire until no frayed ends remain.
14.Attach the speaker wires to the speaker terminal connectors. Connect the negative output from the amplifier to the black terminal. Connect the positive output from the amplifier to the red terminal.
15.Set the speaker configuration switches on the rear of the speaker (see Setting the Speaker Configuration Settings).
16.Install the speaker in the frame. Screw the enclosed
17.Repeat steps 1-16 for each speaker being installed.
18.After making tonal adjustments on all speakers (see Setting the Speaker Configuration Settings), install the grill into the speaker.
3