Siemens SANTIS-ab user manual PABX-Switch, Restrictions

Page 18

PABX-Switch

Command-No / Meaning		Parameter value		Default
320	address selection	0	= standard	0
		1	= PABX

If both the a/b-interfaces are connected to a PABX, this parameter should be set to ‘1’.

Restrictions:

NT+2ab/CA restr.: Can only be set by authorized persons.

Pairgain: Automatically set to ‘1’ and can not be changed.

18

Image 18

Contents SANTIS-ab Siemens Contents Safety Instructions Operating Modes NT+2abPairgain Installation Page Configuration Page Page Page Table of Configuration Commands Parameter-ResetRestrictions for NT+2ab/CA restr. and Pairgain Multiple Subscriber Number MSN Hot Line Emergency Mode Priority Switch RestrictionsType of Terminal Selection HLC HLCClear Back Time Delay Switch PABX-Switch Metering Pulse Switch Call Waiting Tone Switch ∗∗ 390 100 # Metering CalculationCalling Line Identification Restriction Clir Switch 210 1 # Configuration Example Remarks Troubleshooting Pin Allocations of the Sockets USER11.DOC