Premier Mounts installation instructions XL6000CM Projector Bracket Installation Instructions

Premier Mounts

3130 E. Miraloma Ave.

Anaheim, CA 92806

Phone: (800) 368-9700 Fax: (800) 832-4888 techsupport@mounts.com www.mounts.com

XL6000CM

Mounting

Bracket

HC5000

Safety

Strap

HC5000 Safety Bracket Installation

1.Once the XL6000CM has been attached to the projector, the safety strap must be attached to the mounting bracket.

2.Place the safety bracket over the mounting holes and insert two (2) M4 x 10mm knurls knobs and tighten.

M4 x 10mm

Knurl Knobs

XL6000CM

Mounting

Bracket

XL55OU

Safety

Strap

XL55OU Safety Bracket Installation

1.Once the XL6000CM has been attached to the projector, the safety strap must be attached to the mounting bracket.

2.Place the safety bracket over the mounting holes and insert two (2) M4 x 10mm knurls knobs and tighten.

Screwdriver

M4 x 10mm Phillips Head Screw

1.Invert the projector and place it on a soft and flat surface. Remove any foot levelers that might possibly prevent the correct installation of the bracket.

2.Locate the three mounting points located on the bottom of the projector.

3.Line up the mounting points on the projector with the mounting holes on the XL6000CM mounting bracket.

1.Using a screwdriver, secure the XL6000CM mounting bracket using three

(3) M4 x 10mm Phillips Head screws. Do not over tighten these screws. Overtightening the screws may result in damaging the threaded inserts on the projector.

Please refer to the Base Box Installation Instructions to attach the Base Box to the XL6000CM mounting bracket.

The projector (shown above) is for illustration purposes only.