Philips SRP5107/27 manual Learning button functions, Controlling combo devices, Part of the combo

SELECT OK

SAT

6	............................................ thumbs Up/Down. Set your
		Thumbs ratings.
	P 4 and P 3	select previous (4)/next (3)
		page in Replay TV guides and
8	Q.SKIP	menus.
	..........................................	skips 30 seconds of a recorded
9		or delayed show.
	SUBTITLEL1	turns the subtitles on/off.
	INST.REPLAY	replays the last 7 seconds
		(Replay) or 8 seconds (TiVo) of
	L2	a program.
	ADVANCE	catches you up to the live
	PREV.CH	broadcast.
	REPEAT	repeats current chapter/track.

*TiVo and Replay are registered trade marks of their respective owners.

Notes

•This method can be applied similarly to all combo devices (TV/DVR,TV/VCR,TV/DVD, etc.) and is available for all device modes.

•Note that this feature is not supported by all codes.

3.3Learning button functions

If you miss certain functions from your original remote control on the SRP5107, the SRP5107 can learn these

functions. You can store a function underLEARN		any of the
available buttons, except under the	button. Any

function already stored under a button will be deleted. The SRP5107 is equipped with two dedicated buttons for learning additional functions: L1 and L2 .

Using the universal remote control English

3.2Controlling combo devices

Some combo devices (e.g.TV/DVR,TV/DVD, DVD/DVR, etc.) have separate buttons on the original remote control to select the part of the combo device to be controlled.

For example, if your combo device is a DVD/DVR then its original remote control might have separate DVD and DVR

1 Make sure that you have the original hand.

2 Select the desired device

(e.g. DVD). Press the DVD device selection button to select DVD.

remote control at

	LEARN
				POWER
TV	DV	R
			D
		DV
	VCR
			CBL
	HD
			AU	X

buttons for selection of the combo part you wish to operate. The equivalent button functions can be found on your Philips remote control by using the device selection buttons.

Example for a DVD/DVR combo:

3Place both remote controls on a flat surface (like a table) and aim them head-to-head with about 5 - 10 cm in between.

PO WER

		CBL		UX
	VD		A
D

1 Set up the remote control for each part of the combo as
	described in chapters 2.3 and 2.3.2. In this example for
2	both DVD and DVR.
	Press the DVD device selection
	button twice to select the DVD		LEARN
	part of the combo.				P
		TV			OWER
			DV	R
					D
				DV
		SAT	VCR
					CBL
			HD
			2 x		AUX

					LEARN	R	VCR
						DV		H	D
4 Keep the LEARN button and the
		5 sec.		LEARN
button you wish to learn on the								POWER
SRP5107 (e.g. the	button)		TV	DV	R	D
			SAT	VCR		VD	CBL
pressed simultaneously for 5				HD
						AU		X

seconds, until the red Setup light lights up.

•The remote control is now in learn mode.

5Press and hold the button that you wish to learn on the

Press the DVRVCR device selection button twice to select the DVR part of the combo.

LEARN

TV	DV	R
SAT	VCR
	HD
2 x

		POWER
DV	D
	CBL
	AU	X

original remote control until the red Setup light blinks twice and then goes out to confirm that learning was successful.

•The remote control has now learned the new function.

12 EN EN 13