Philips SRP5107/27 manual Service and support, Resetting a button to its original function, Setup

Note

•It may occur that learning a button function fails the first time. The red Setup light will then give 4 short blinks and go out. In this case, please try again.

•If you keep having trouble learning button functions, check the batteries in both SRP5107 and original remote control and replace if necessary.

•It may also be that the remote control learn memory is full (a total of about 60 buttons can be learned). In this case you can reset one or more buttons to their original functions in order to create memory space. For this, see chapter 3.4.

3.4Resetting a button to its original function

If an improved button (see chapter 2.3.3) still does not function as expected, you can always reset the button to its original function.

When resetting a button to its original function, any learned function stored under the button will be deleted.

1	In the current					5 sec.
	device mode, keep digit buttons							1
	1	and	6	pressed						2
								4				3
	simultaneously for 5 seconds,								5
							7				6
	until the red Setup light				lights				8
						ENTE		R			9
	up.								0
						SUBT				Q.SKIP
2	• The remote control is now in setup mode.
	Press digit buttons						1		2
											3
	9	, 9	and	6 , in that order.			4
									5	6
	• After each button press					7			8
		the red Setup light			blinks	ENTE	R			9
									0
						SUBTITLE				Q.SKIP
		once.					L1		L2	REPEAT
						IN				PREV.CH
3 Press the button that you wish						ST.REPLAY
										U
	to reset twice.								P
	E.g. the 22 button.										P

•After each button press

the red Setup light	blinks	2 x
once.
• The red Setup light	will blink one more time to

confirm that the button was succesfully reset to its original function.

• The button can now also learn a new function, if desired.

3.5	Resetting the original functions
	of the remote control (Factory Reset)									English
In some cases it may be useful to reset the original functions
of the remote control.
E.g. if the remote control memory is full while you wish to
set it up for a specific device or learn an extra function to it.										support
The remote control will then be reset to the default factory
settings and all user settings will be deleted.
1 In the current device mode,			5 sec.							and
										Service
keep digit buttons 1		and 6			1
pressed simultaneously for 5							2
					4				3
seconds, until the red Setup light						5
				7				6
	lights up.					8
			ENTE		R			9
• The remote control is now						0
			SUBT					Q.SKI
	in setup mode.
2 Press digit buttons				1		2
9	, 8 and 1 , in that order.			4				3
						5
• After each button press			7					6
						8
	the red Setup light	blinks	ENTE	R				9
						0
	once.		SUBTITLE					Q.
								SKIP
•	The red Setup light	will		L1		L2	REPEAT

blink one more time to confirm that the original functions of the remote control were succesfully reset. Any extra functions have been deleted.

4Service and support

4.1Frequently asked questions

In this chapter you will find answers to the most frequently asked questions about your universal remote control.

Setup

I cannot enter setup mode.

Battery level too low or battery lifetime came to an end.

•Replace the batteries. See chapter 2.1.

The brand code for my device is missing in the ‘Shortlist of brands’ in the Quick Start Guide.

The ‘Shortlist of brands’ only mentions the most common brands of TV, DVR, DVD player/recorder, Cable/Satellite box, DTV,VCR, HD and auxiliary equipment.

14 EN EN 15