Premier Mounts CPD10WALLARM installation instructions Contents, Weight Capacity

Page 2

 

CPD10WALLARM

Contents

 

Weight Capacity

2

Warning Statements

2

Installation Tools

3

Parts List

3

Determining the Installation Height

4

Wood Stud Installation

5

Removing the End Cover

6

Attaching the Projector Arm

7

Extension Arm Installation

8

Adjustable Mounting Bracket Installation

8

Adjustable Mounting Bracket Installation (cont.)

9

Base Box Installation

9

Projector Bracket Installation

10

Throw Distance Calculation

11

Utilizing the Storage Feature

12

Cable Management

13

Technical Specifications

13

Warranty

14

Disclaimer

14

Weight Capacity

 

 

THE WALL STRUCTURE MUST BE CAPABLE OF HOLDING

Maximum Projector Weight: 50lbs.

FIVE (5) TIMES THE WEIGHT OF THE PROJECTOR. IF NOT,

 

THEN THE WALL STRUCTURE MUST BE REINFORCED.

Warning Statements

PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS MUST BE READ AND

COMPLETELY UNDERSTOOD. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION FOR FUTURE REFERENCE.

PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN MUST BE FOLLOWED, AS OUTLINED IN THESE INSTALLATION INSTRUCTIONS. FAILURE TO DO SO COULD RESULT IN PROPERTY DAMAGE, SERIOUS

PERSONAL INJURY, OR EVEN DEATH.

SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE ASSEMBLY OF THIS PRODUCT. USE

PROPER SAFETY EQUIPMENT AND TOOLS FOR THE ASSEMBLY PROCEDURE TO PREVENT PERSONAL INJURY.

PREMIER MOUNTS DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY PREMIER MOUNTS PRODUCT FOR PURPOSES OTHER THAN THOSE FOR WHICH IT WAS DESIGNED OR DAMAGE CAUSED BY

UNAUTHORIZED ATTACHMENTS OR MODIFICATIONS, AND IS NOT RESPONSIBLE FOR ANY DAMAGES, CLAIMS, DEMANDS, SUITS, ACTIONS OR CAUSES OF ACTION OF WHATEVER KIND RESULTING FROM, ARISING OUT OF OR IN ANY MANNER RELATING TO ANY SUCH USE, ATTACHMENTS OR MODIFICATIONS.

At least two qualified people should perform the assembly procedure. Personal injury and/or property damage can result from dropping or mishandling the projector.

If mounting to wall studs or ceiling studs, make sure that the mounting screws are anchored into the center of the wall studs or ceiling studs. Use of an edge-to-edge stud finder is recommended.

Be aware of the mounting environment. If drilling and/or cutting into the mounting surface, always make sure that there are no electrical wires in wall. Cutting or drilling into an electrical line may cause serious personal injury.

Make sure there are no water or natural gas lines inside the wall where the mount is to be located. Cutting or drilling into a water or gas line may cause severe property damage or personal injury.

This product is intended for indoor use only. Use of this product outdoors could lead to product failure and/or serious personal injury.

Do not install near sources of high heat. Do not install on a structure that is prone to vibration, movement or chance of impact.

Contact Premier Mounts with any questions: (800) 368-9700 techsupport@mounts.com

Page 2

Visit Premier Mounts website at http://www.mounts.com

Installation Instructions

Image 2
Contents Installation Instructions Contents Weight CapacityInstallation Tools Parts ListDetermining the Installation Height Wood Stud Installation StepProceed to the Removing the End Cover section Wood Stud Installation contdRemoving the End Cover Proceed to the Attaching the Projector Arm sectionProceed to the Extension Arm Installation section Attaching the Projector ArmExtension Arm Installation Adjustable Mounting Bracket InstallationProceed to the Projector Bracket Installation section Base Box InstallationProceed to the Base Box Installation section Projector Bracket Installation Proceed to the Throw Distance Calculation sectionProceed to the Utilizing the Storage Feature section Utilizing the Storage Feature Cable Management Technical SpecificationsWarranty Disclaimer