CPD10WALLARM
Attaching the Projector Arm
Step 1
Locate the mounting hook cutout on the top of the wall plate.
Tilt the arm slightly and gently insert the mounting hooks into the mounting hook cutouts.
Slowly lower and let the projector arm rest against the wall plate.
If using the storage feature of the product, it may
be easier to route any wiring at this time (please see the "Cable Management" section).
MAKE SURE THE PROJECTOR ARM IS FULLY SEATED BEFORE RELEASING THE UNIT.
Mounting Hook Cutout
Mounting Hooks
CPD10WALLARM
Step 2
Locate the two (2) lock mounting points on the projector arm. These two points will be aligned with the lock mounting points on the wall plate.
Using a security wrench, insert and tighten two (2) M5 x 8mm security head screws.
Do NOT overtighten these screws.
Proceed to the "Extension Arm Installation" section.
Lock Mounting Point
M5 x 8mm Security Head Screw
Security Wrench
Installation Instructions | Visit Premier Mounts website at http://www.mounts.com | Page 7 |