RBH Sound 1001RB/210, 1001RB/115 Rear Panel Controls, Power cord is detachable and plugs in here

1001RB Series

1

Rear Panel Controls

1- AC Receptacle:

The power cord is detachable and plugs in here.

2- 540W Amp Only:

540W power amp output for Full-Range operation only. They deliver 540 watts into 4 Ohms. Lower impedances should not be used. Each jack has a minimum of 8 Ohms each. Higher impedances such as 8 Ohms, 16 Ohms, or No Load are acceptable. No damage will result from operating the amplifier with the speakers disconnected.

3- “Speakon” Outputs:

Enables BI-AMP operation by connecting a GK-RBH Series cabinet with the provided 4 conductor Speakon cable. This connects the 50W amplifier allowing the Tweeter control on the front panel to control the signal going to the horn. See Bi-Amp and Normal Operation on page 7 for more information.

Caution:

Do not connect a Speakon cable labeled “Bridge Mode” to the 1001RB. This may result in damage to the amplifier.

Maximum Recommended Load:

One 4 Ohm or two 8 Ohm cabinets on the 540W Amp. One or two 8 Ohm horns on the 50W Amp.

3

2

CAUTION:

UNDER NO CIRCUMSTANCES SHOULD THE 540W AMP AND THE 50W AMP BE CONNECTED TOGETHER OR BE CONNECTED TO THE SAME SPEAKER !!!

Rear Panel Controls

11